Fast Pickup, Automatic Discharge -- The Water Relocator is a very solidly built wet vacs that can move up to 3,000 gallons per hour. The vacuum is rated to move 50 gallons per minute. The discharge sump pump built inside the vac moves 60 per minute. This means that the unit never has to be shut down. It constantly picks up water and discharges it so you never have to stop your operations. Most fire department users say that a 3 hour water pickup job with conventional wet vacs can be done in 30 minutes with the Water Relocator. The vac can also function on "pickup only" mode, and when you're done, roll it outside and flip a switch and it will self-dump. This has enormous value over a conventional vac which requires you to physically lift the unit to dump it, often creating sore backs in the long run for the users.

Powerful Suction - The Power of an Extractor. The Water Relocator features a 105 inch water lift, which is nearly unparalleled among other vacuums. This means the it has enough power to lift water up a column of 105 inches above ground level.

Strainer - Inside the vac is a strainer that catches any debris over 5cm in size. The strainer can be easily dumped by removing the lid of the vac and pulling the strainer out. The good thing about this is that you can operate around dirty areas after fires and not be worried about picking up debris and having it jam the system. Fire department users report no problem using this vacuum around the heavy debris after a fire.

Low Noise -- The Water Relocator generates only 57db of noise. You can literally talk next to it without yelling. This is unparalleled among vacuums of its power.

Overflow Protection -- The vac is "smart" in that it has a built in pressure sensor that will automatically stop any water pickup if you are picking up faster than you discharge. For example, if your discharge hose gets kinked and you couldn't discharge as quickly as you picked up, the vac would stop the pickup for as long as it takes to dump water out of it. Then, once sufficient water was discharged, it would automatically start to suction again.

Injury Prevention -- Since the Water Relocator has automatic dumping of water at the flip of a switch, users never have to physically pick up the vac to dump it. This helps to prevent back injuries since water is very heavy.

Better Customer Service -- Many fire departments face the dilemma of needing to return to service for other emergency calls, yet also needing to stay on the scene of a broken water pipe or activated sprinkler for hours to perform water pickup after an incident. The Water Relocator is a lifesaver and timesaver! What used to take hours with a conventional wet vac or backpack vac now can be done in a much shorter time. Many departments report a typical 3 hour water removal call using conventional wet vacs can be completed in 30 minutes with the Water Relocator.

Powerful Discharge -- If you use a non-collapsible discharge hose, the unit can discharge up to 300 feet. Many fire department users connect an old section of 1-1/2 inch or 1-3/4 inch hose to the discharge port (a special coupler is provided for these users). Because the hose is collapsible and generates more friction loss, the discharge is limited to 100 feet. However, in most cases, users only need 25 feet of discharge hose to reach a drain. The sump pump inside the vac is powerful enough to pump the water up two levels (up to 23 feet vertically), for example, from a basement to the outside through a 50 foot section of fire hose. If you desire, the unit can work in a pickup only mode for up to 17 gallons of water. When the canister if full, simply wheel it outside or to a drain and flip the dump switch and the vac will dump itself.

Durability -- The Water Relocator is German engineered.  Contractor, industry, and fire service users like its durability and power. The Water Relocator comes with a 2 year parts and labor warranty.

• Vacuum

• 1.6 HP (8.5 peak) two stage self cooling bypass motor (offers high suction performance with little chance of ever burning up)

• 140 cfm airflow

• 105 inches static water lift

• 50 gpm suction volume, 60 gpm discharge volume 

• 19 gallon tank size, stainless steel

• 86 lbs.

• 23 foot cord with GFI protection

• 24"l x 23"w x 38"h Integrated ground fault interrupter

• 1.5"x 13' crush proof suction hose (can be made longer-extra cost)

• Tiltable canister -- canister tilts on frame of cart for easy dumping

• Industrial squeegee floor nozzle

• Metal two piece chrome wand

• Metal filter strainer on intake

• Accessory holder and tool deposit

• Cable hook

• Soft start technology (increases life of motor)

• Super Quiet (SQ) 57 decibel noise level

• Overflow protection - vacuum will not overflow

• Can be used in "pick up" only mode, then roll outside, flip switch, and it self dumps 

• 2 year parts and service warranty

• Internal Pump

• 2 HP motor

• 60 gpm discharge volume

• Water overflow protection

• Optional Accessories

• The Water Relocator does not come with discharge hose, however, it does come with a 1.5" iron pipe thread or NST (National Standard Thread) connection for the discharge port so you can attach hose onto it easily. Discharge hose can be purchased in 25, 50 and 100 foot sections. Suction hose can be purchased to extend the length up to 40 feet total.  See Parts and Accessories section under HOSES to purchase discharge hose.